How to Program your One For All® remote
( URC-2060, URC-2062)
Set Up
Your remote will set up in one of the following ways:
Set Up #1
- Press the button for the device you want to program, then release.
- Press and hold the Magic button until the red LED gives a delayed blink.
- Continue holding the Magic button while you enter your 3 digit code.
- You should receive 2 quick flashes after entering your code.
Look on the back of your remote for the instructions. If they match these, press here for more instructions for his remote.
Set Up #2
- Press the button for the device you want to program, the release.
- Press and hold the Magic button. You will see two blinks on the remote. Release.
- Press the three digit code for the device you want to program.
- You will see two blinks. Your remote is now programmed for that device.
Look on the back of your remote for the instructions. If they match these, press here for more instructions on this remote.
|